Another holder I needed to update was the scraper holder that sat on the shelf I removed. The original holder was a hunk of 2×4 that was kerfed on the table saw, and attached to a base plate. This worked well (and took up very little space), but wouldn’t work on the wall as well. (Or maybe it would, I may revist that later 🙂 ).

I used a short piece of 1×2 stock, and marked cross lines every 1/2″ along most of the length. Then I set a bevel angle on the side, and kerfed it by hand. That was it! I screwed it to the wall, and I’m ready to go.